On Tue, Nov 30, 1999 at 07:14:43PM +0100, Dominik Vogt wrote:
> On Tue, Nov 30, 1999 at 12:15:05PM -0500, bgiaccio_at_psrw.com wrote:
> > It sounds like your headders are broken. Try runnin
> > cc -DHAVE_CONFIG_H -I. -I. -I.. -I.. -g -c -E ClientMsg.c > preprocess
> >
> > That will just run the preporcessing step of the compiler then if you
> > look in preprocess at the line being complained about you can work up
> > and find the syntax error, from there find out which header has the
> > syntax error, then see if the actual header has a #define that should be
> > getting set by the compiler.
>
> Hm, no syntax error. Most likely the compiler is broken. If I configure
> with the HP-UX compiler but the use gcc to compile the output of the
> preprocessing step I get no errors.
>
Then the HP compiler is probablly not an ansi C compiler but a k&r so just
go with gcc.
Brad
--
--- There are two kinds of knowledge, you either know the answer or
you know where to find it
-Kane, Johnson, and anonymous
--
Visit the official FVWM web page at <URL: http://www.fvwm.org/>.
To unsubscribe from the list, send "unsubscribe fvwm" in the body of a
message to majordomo_at_fvwm.org.
To report problems, send mail to fvwm-owner_at_fvwm.org.
Received on Tue Nov 30 1999 - 12:33:23 GMT