----------
Cornelius Moeckel <moeckel_at_zeus.ph1.Uni-Koeln.DE> writes:
>
> hi,
> we need desperately your help !
> After compiling the fvwm2 with gcc 2.7.2 we had startup problems.
> We copiled it with the -g option on a HP-9000/735 running HP-UX 9.0.7.
> The Makefile.std has been used to coplile the files in FvwmConfig.
> After starting the fvwm2 the following messages have been
> written to stdout:
>
> [FVWM][main]: <<DEBUG>> Entered, about to parse args
> [FVWM][main]: <<DEBUG>> Done parsing args
> [FVWM][main]: <<DEBUG>> Installing signal handlers
> [FVWM][main]: <<DEBUG>> Setting up rc file defaults...
> [FVWM][main]: <<DEBUG>> Running config_command...
> [FVWM][main]: <<DEBUG>> Done running config_command
> [FVWM][main]: <<DEBUG>> Entering HandleEvents loop...
> [FVWM][HandleEvents]: <<DEBUG>> Routine Entered
> ....
>
> After this message the terminal is totally locked up!
Most likely cause, you have no $HOME/.fvwm2rc.
^
(Chuck, looking at "ReadFile()" in read.c, there doesn't seem to be
sufficient debugging (or error) output when the file to read is
non-existent.)
--
Dan Espen Phone: (908) 699-5570
dane_at_bae.bellcore.com
444 Hoes Lane Room RRC 1C-214
Piscataway, NJ 08854
--
Visit the official FVWM web page at <URL:http://www.hpc.uh.edu/fvwm/>.
To unsubscribe from the list, send "unsubscribe fvwm" in the body of a
message to majordomo_at_hpc.uh.edu.
To report problems, send mail to fvwm-owner_at_hpc.uh.edu.
Received on Fri May 03 1996 - 09:29:35 BST